music

OSdata.com

processor emulator manual
commands
change

summary

    The change command is used to change the state of attributes and quantities in the source code emulator.

commands
manual table of contents
emulator

processor emulator manual
commands
change

summary

    The change command is used to change the state of attributes and quantities in the source code emulator.

change p0

    Changes the source code emulator to direct subsequent commands and instructions to processor p0. Use upper case.

CHANGE P0

change p1

    Changes the source code emulator to direct subsequent commands and instructions to processor p1. Use upper case.

CHANGE P1

change registers

    Changes the value of a register in the source code emulator. Use upper case.

CHANGE ACC 0123

    See registers for a list of registers.

    The source code emulator does not yet validate that the values you assign are legitimate.

commands
manual table of contents
emulator

contact

    If you find this interesting and want to contact me, write to Milo, PO Box 5237, Balboa Island, California, 92662, USA.

if you want to make a tax-deductible donation to the StarTree107 Foundation to support this educational work, contact Dr. Barry at 949-675-5778

    Challenge: Homeless or Facebook